Air King VS80 Installation Instructions

pApER bAg systEms:
household contaminants often choose the paper bag option for capturing dust and debris to reduce exposure
to material collected. The VS80 power unit is designed to accommodate a paper bag if this option is preferred.
Even with the use of paper bags you retain the option of the plastic bin liner and secondary filtration from the
inverted bag. The use of a paper bag has decided advantages if the installation is not vented to the outdoors.
Important: To reduce
pic. 1
the risk of unintentional
operation of your power unit
setup of your VS80 power unit
should be performed with
the unit disconnected from
any power source. This can
be confirmed by verifying he
power unit LED is unlit. (See
Picture # 1)
pic. 3
Select the paper bag entry port. ( Image # 5 ) You will notice there
is a cured surface designed to follow the contours of the machine.
Press the deflector end of the entry port through the side of the ma-
chine so the opening faces the bottom of the collection bin. ( Image
# 6 ). It is not necessary to glue or use a fastener as the design of the
entry port will permit it to seat firmly into the side of the VS80 power
unit creating a suitable seal.
pic. 7
When it comes to empty the collection bin individuals sensitive to dust and other
Release the dust collection bin from below your VS80 power unit by releasing the two
latches on opposite side of the bin.
Setting up the VS80 power unit for paper bags requires the removal of the plastic cone
below the inverted bag. ( Image # 3 ) It is not necessary nor recommended that the
inverted bag be removed as it provides additional filtration and protects the motor from
dust and other contaminants should a paper bag failure occur. ( Image # 4 ) Retaining
the plastic cone permits you to revert to an inverted bag system in the future.
pic. 4
pic. 8
Corporate Headquarters for United States division:
820 Lincoln Avenue • West Chester, PA 19380
pic. 2
Select the multi layer high filtration paper bag
provided with your machine and expand it to expose
the maximum surface area of the filter. ( Image # 7 )
( Image # 8 ) Reach inside the machine and press the
bag opening onto the entry port stem until it reaches
the ring evidenced on the bag side of the entry port.
( Image # 9 ) With the bag in place replace the collec-
tion bin by relatching the bin to the power unit.
pic. 9
Ph. 800.465.7300
Website: www.airkinglimited.com
Your VS80 power unit is de-
signed to permit either a right
hand or left hand connection to
the piping system from your home
to make connection to the system
as easy as possible. Once the
preferred entry point is selected
move the plug to the opposite side
of the machine and push firmly
into place. (See Picture # 2)
pic. 5
COnTInUED On bACk
pic. 6
#F51070