Hoover U5416-900 - TurboPower Upright Vacuum Owner's Manual page 5

1-11
Push bolt into hole on lower front of handle.
If bolt will not go through hole easily,
check the following:
the bracket is properly positioned
the handle is pushed completely down
1-14
O
Continue to slide rack down until bottom of
rack is below lower cord hook (O). Snap
one side of rack then the other onto lower
handle.
1-17
Slide large tab (R) on bottom, back of bag
compartment into slot between the bracket
and the lower handle.
5
1-12
Place nut in recessed area at back of
handle. Hold nut in place while tightening
bolt securely with a screwdriver.
Note: Only one nut is needed on this
model. The extra nut is not required but
has been provided for your convenience.
1-15
Slide rack down handle until upper hooks
(P) snap into slots (Q) on handle.
1-18
R
S
Note round opening and hooks (S) on
back of bag compartment. Place opening
over dirt tube (T) and align hooks with slots
in handle.
Push very firmly to snap both hooks into
handle.
Pull on bag compartment to make sure it is
completely snapped to handle.
1-13
With side of rack marked TOP FRONT fac-
ing away from cleaner handle, pull cord
through rack and lower rack over handle
as shown. Slide rack down handle.
1-16
P
Q
Pull bag door latch forward and remove
door. Set bag door aside.
1-19
T
Align opening (U) in paper bag with dirt
tube (T) inside bag compartment.
U
T
Continued