Table of Contents
Advertisement
Installation Location
The appliance should be set up in a well ventilated, dry room.
Energy use is affected by the ambient temperature. The appliance
should therefore
Ð not be exposed to direct sunlight;
Ð not be installed next to radiators or other sources of continuous
heat;
Ð only be installed at a location whose ambient temperature corre-
sponds to the climate classification, for which the appliance is desi-
gned.
The climate classification can be found on the serial plate, which is
located at the left on the inside of the appliance.
The following table shows which ambient temperature is correct for
each climate classification:
Climate classification
Your appliance needs air
For safety reasons, minimum venti-
lation must be as shown Fig.
Attention: keep ventilation ope-
nings clear of obstruction;
Reversing the door
The side at which the door opens can be changed from the right side
(factory adjustment) to the left side, if the installation site requires.
Warning! Disconnect from the electricity supply before reversing the
door.
SN
N
for an ambient temperature of
+10 to +32 ¡C
+16 to +32 ¡C
50 mm
D567
min.
2
cm
200
19
Advertisement
Table of Contents
