Table of Contents
Advertisement
Symptom
The compressor does not
start immediately after chan-
ging the temperature set-
ting.
Water on the floor or on sto-
rage shelves.
If, after carrying out the necessary checks there is still a fault with
your appliance please contact your local AEG Service Force Centre.
In guarantee customers should ensure that the suggested
checks have been made as the engineer will make a charge if the
fault is not a mechanical or electrical breakdown.
Please note that proof of purchase is required for any in-guarantee
service calls.
Changing the light bulb
Warning! There is a risk of electric shocks! Before changing the
light bulb, switch off the appliance and unplug it, or pull the fuse or
the circuit breaker. Light bulb data: 220-240 V, max. 15 W
1.
To switch off the appliance, turn
the temperature regulator to posi-
tion "0".
2.
Unplug the mains plug.
3.
To change the light bulb, unscrew
the light cover.
4.
Unhook the light bulb cover as
shown.
5.
Change the defective light bulb.
6.
Refit the light bulb cover and the
screw.
7.
Put the refrigerator back into ope-
ration.
Possible Cause
This is normal, no error has
occurred.
Water drain hole is blocked.
Remedy
The compressor starts after
a period of time.
See the "Cleaning and
Care" section.
D411
15
Advertisement
Table of Contents
