Service Adjustments; Accessing Diagnostic Menu; Aging; Accessing Service Menu - Sony KLV32S400A - 32" Multi-System Dual Voltage HDTV LCD TV Manual

5-1. Accessing Diagnostic Menu

1. While TV set on standby, press the following sequence on
the remote commander (RM-GA011).
On screen
Channel 5
display
2. The following menu will appear on the screen:
Figure 1
3. To reset, select 'RESET' using remote commander and
press .
4. To quit the diagnostic menu, turn off and on the TV set.

5-2. Aging

1. Aging setting: Set no signal and monitor as aging mode.
2. Aging condition:
Aging condition before white balance adjustment is as
follows:
Supply voltage : Rating
Time : 20 minutes or over
(AGING TIMER registor setting)
Ambient Temp : 22 ~ 28 degree
Brightness : Brightness is set by aging mode.
Input : Set no signal except digital and
analog RF (video/component/PC).
3. LED lightning pattern during aging:
In case the AGING TIMER > 0
Green (0.5s) --> Off (0.5s) --> Green (0.5s) --> Off (0.5s)
Note: Green (Power LED is ON / OFF)
In case the AGING TIMER = 0
Green (3s) -->Off (3s) --> Green (3s) --> Off (3s)
Note: Green (Power LED is ON / OFF)
Note: If set has been put on surface down, static electricity
causes brightness surface irregularity. If such happens, turn
the set over or place it in upright position for more than 30
seconds. Once surface irregularity is cleared, check the set.
SECTION 5

SERVICE ADJUSTMENTS

POWER
Volume (-)
– 21 –

5-3. Accessing Service Menu

1. While TV set on standby, press the following sequence on
the remote commander (RM-GA011).
On screen
Channel 5
display
2. The following menu will appear on the screen:
Service Menu
Status
W/B
Service
Figure 2
3. View Menu Listing
Press the 'down' arrow button to choose white balance
(W/B) and then press 'right' arrow button to view W/B
adjustment items.
Service Menu
W/B
R_DRIVE
G_DRIVE
B_DRIVE
COLOR _SAVE
Figure 3
4. Select Menu Item
Press the 'up' or 'down' arrow button to select the item you
want to adjust.
5. Increase/Decrease Data Value
To increase the data value, press the 'right' arrow button
whereas to decrease, press the 'left' arrow button.
6. Save/Cancel Data Value
To save the data value changes, firstly press the 'down'
arrow button to select 'COLOR SAVE' then use 'right' arrow
button to select 'OK' and press the
data value changes, use 'down' arrow button to select
'Cancel' and press the
KLV-26,32,32/H/S,37 S400A
Volume (+)
POWER
0
0
0
OK
button. To cancel the
button.
RM-GA011