Installing Hard Disk Drives; Setting The Raid Item In Bios - Asus KGMH-D16 QDR User Manual

5.1.2

Installing hard disk drives

The motherboard supports Serial ATA for RAID set configuration. For optimal
performance, install identical drives of the same model and capacity when creating
a disk array.
To install the SATA hard disks for RAID configuration:
1. Install the SATA hard disks into the drive bays following the instructions in the
system user guide.
2. Connect a SATA signal cable to the signal connector at the back of each drive
and to the SATA connector on the motherboard.
3. Connect a SATA power cable to the power connector on each drive.
5.1.3

Setting the RAID item in BIOS

You must set the RAID item in the BIOS Setup before you can create a RAID set
from SATA hard disk drives attached to the SATA connectors supported by
AMD SP5100 chipset. To do this:
1. Enter the BIOS Setup during POST.
Go to the Main Menu > Storage Configuration, then press <Enter>.
2.
Set SATA Port1-4 to [RAID] and SATA Port5-6 will be set to [RAID] too.
3.
4. Press <F10> to save your changes and exit the BIOS Setup.
Refer to Chapter 4 for details on entering and navigating through the BIOS
Setup.
5-4 Chapter 5: RAID configuration