Scan Area Dialog Box - Kodak i1405 Setup Manual

Scan Area dialog box

A-61661 May 2010
The Scan Area dialog box allows you to define the amount of image
data which is returned to your PC.
NOTE: Select the side and image to be defined by highlighting Front
Image #1, Front Image #2, etc. based on the cropping option
(either Fixed to Transport or Relative to Document) selected
for each of these in the Main tab. The scan areas defined for all
camera selections are independent.
Page Size ⎯ the default paper size is set when a scanner is selected.
You can choose a different paper size using the drop-down list.
NOTE: Page Size and Page Layout selections also appear on the
Layout tab. If you make a change on the Scan Area dialog box,
the same selections will be displayed on the Layout tab and vice
versa.
Page Layout
• Portrait: displays the image orientation in the shape of a
conventional portrait, where height is greater than width.
• Landscape: displays the image orientation in the shape of a
conventional landscape painting, where width is greater than height.
Area
• Snap ⎯ enable this option to control the dimensions of the preview
area to fixed 1/8-inch increments. This option is not available in
Pixels mode.
• X: the distance from the left end of the scanner to the left-edge of the
scanning area.
• Y: the position from the top end of the document to the top end of the
scanning area.
• Width: the width of the scanning area.
• Height: the height of the scanning area.
Units — select whether you want the area to be defined in Pixels,
Inches or Centimeters.
11