Advertisement
Quick Links
American DJ
4 CHANNEL FLASH TUBE CONTROLLER
POWER
Model: Flash-2C™
SPECIFICATIONS:
Power: 110V/60Hz
Weight: 8 lbs.
Size:
19" x 3.5" x 5"
Fuse: 15A
SET UP:
Link the Flash Tubes to the Flash-2C™ by inserting tube
connectors into controller sockets on the back of unit.
The maximum length to first Flash Tube™ is 10 ft, any
more and you will have to use a Flash Buffer.
If you connect more than 30 Flash Tubes in any single
line use a Flash Buffer™ to boost signal.
At the end of each line connect a Flash-Term™. If you
don't use one the Flash Tubes will work but not properly.
Plug Flash-2C™ and any Flash Buffer™ into power.
Refer to Operating instructions for use.
Caution!
Always use appropriate cables and
connectors. Remember to always replace with
same fuses. Always keep controllers dry. Don't
exceed load and length limitations
American DJ
®
Flash-2C
ZONE CONTROL
1
2
3
MODE SELECT
®
LOS ANGELES, CA. 90058 USA • www.americandj.com
User Instructions
4
SYNC
AUTO
FLASH MANUAL
Thank
American
convenience this products ready to be
used, there is no assembly required.
Please
instructions before installing or using
your new unit.
Operating Instructions:
The American DJ® Flash-2C, flash tube controller is
ideal for mobile DJ's and club use. One Flash-2C will
control 4 expandable lines of Flash Tubes.
POWER- ON & OFF
1,2,3,4 - ON & OFF for individual lines.
SYNC - All tube flash at the same time
AUTO - Flashes line of tubes one by one
SPEED knob - Controls speed of chase.
RATE knob - Controls rate of pulse (ie. speed
between triggering strobe) of the Flash Tubes.
TRIGGER - starts a flash run when in manual mode
MANUAL - allows you to TRIGGER flash manually.
MODE SELECT - Choose 1 of 4 modes to chase in.
1.
2.
3.
4.
For service, contact your American DJ
™
PULSE CONTROL
SPEED
RATE
AUDIO
TRIGGER
you
for
purchasing
product.
DJ®
read
the
Rebound
Crossover
Reverse
Forward
this
For
your
following
.
dealer
®
Advertisement
