Table of Contents
Advertisement
• Even if you have set [Computrace (R) BIOS Module] to [Enable], this setting may return to [Disable] after repairs to
the motherboard, etc. have been made.
NOTE
Consult Absolute Software Corp. before disposal.
Refer to the following URL for Computrace
service is only available in certain regions.
http://www.absolute.com
1
Turn on or restart the computer, and press
played.
The Setup Utility starts up.
If the password is requested, enter the Supervisor Password.
2
Select the [Security] menu, then select [Computrace (R) Sub-Menu] and press
3
Select [Computrace (R) BIOS Module], and set to [Enable].
4
At the confirmation message, select [Execute] and press
5
At the reconfirmation message, select [Execute] and press
6
Press
.
F10
At the confirmation message, select [Yes] and press Enter.
The computer restarts.
Maintenance
To clean the LCD panel and touch pad
Wipe lightly with a gauze or other dry, soft cloth.
To clean areas other than the LCD panel and touch pad
Wet a soft cloth with water or a diluted kitchen cleanser (neutral), wring the cloth out thoroughly, and wipe the dirty area
gently. Using a detergent other than a neutral kitchen cleanser (e.g., a weak alkali cleanser) may adversely affect
painted surfaces
CAUTION
Do not use benzene, thinner, or rubbing alcohol since it may adversely affect the surface causing discoloration, etc.
Do not use commercially-available household cleaners and cosmetics, as they may contain components harmful to
the surface.
Do not apply water or detergent directly to the computer, since liquid may enter inside of the computer and cause
malfunction or damage.
®
software for installation and available service regions. Note that this
while [Panasonic] boot screen is dis-
F2
.
Enter
.
Enter
.
Enter
17
Advertisement
Table of Contents
