Removing The Battery; Charging The Battery - Epson PictureMate Flash - PM 280 - PictureMate Flash Compact Photo Printer Product Information Manual

4. Insert the battery as shown until it clicks into place.

Charging the Battery

After you install the battery, you need to charge it by
connecting the AC adapter and plugging in the printer.
The power light flashes during charging when PictureMate is
off. It takes about 2 hours to fully charge the battery when
PictureMate is off. It takes longer when you use PictureMate
while it is charging.
The power light turns off when the battery is fully charged (if
PictureMate is turned off).
The following battery status icons appear in the upper right
corner of the photo viewer screen:
Charging
2/3 full
1/3 full
Low
Almost out
Battery
status icon
Note: If you are running PictureMate with the battery, the printer
turns off automatically after 15 minutes if it is not being used (unless
PictureMate is connected to a computer and a memory card is
inserted). Press the

Removing the Battery

If there is a problem with your battery, or you want to replace
it with one that is already charged, you need to remove the
battery.
1. Make sure PictureMate is turned off.
2. Release the latch and remove the battery.
3. Replace the battery cover.
Checking the Print Pack Status
You can check the status of your Print Pack on the
PictureMate photo viewer screen.
1. Press .
Menu
2. Press or to highlight
You see the status displayed on the photo viewer screen:
3. Press to exit.
OK
Note: If the screen displays a Print Pack low message, you should
buy a new PictureMate 200 Series Print Pack.
8/06
PictureMate Flash (PM 280)
On button to turn it back on.
Check Print Pack
– 100%
– 50%
PictureMate Flash (PM 280)
and press .
OK
- 13