AEG ÖKO-ARCTIS SUPER 3173-4GS Operating Instructions Manual page 35

Malfunction
Large accumulation of
frost in the appliance,
perhaps also at the door
seal.
Unusual noises.
The compressor does not
start immediately after
pressing the FREEZE but-
ton, or after changing the
temperature setting.
Compressor does not start
after appliance is switched
on.
Possible cause
Door is not properly sealed
(perhaps after re-hanging
door).
Appliance is not level.
Appliance is in contact
with wall or other objects.
A part at the back of the
appliance, e.g. a tube, is in
contact with another
appliance part or the wall.
This is normal, no error has
occurred.
Within the first 5 minutes
after switching the
appliance on, the electro-
nics initialise a self-test.
What to do if ...
Remedy
Carefully warm the door
seal with a hand-held hair
dryer at those points which
are not airtight (no warmer
than approx. 50°C). At the
same time, shape the war-
med door seal by hand, so
that it is again properly
seated.
Readjust the front levelling
feet.
Push appliance away a
short distance.
Bend this part away care-
fully if necessary.
The compressor starts
after a period of time.
The compressor is started
automatically, after the
self-test has been comple-
ted.
35