Kodak 8461444 - Max Flash Camera One Time Use Setup Manual

CIS-256
June 2004
CURRENT INFORMATION SUMMARY
1
Wind Off
• Make sure "0" is aligned with the arrow in the
frame-counter window.
• If the "0" is not aligned, grip the camera and
cover the lens.Then press the shutter button
and turn the thumbwheel (repeat these steps
until the film is fully rewound).
The film is fully rewound when the thumb-
wheel rotates freely and does not stop or lock.
Break Off Film Door
3
• Using the special tool, hold the camera firmly
and pull upwards to break off the film door
and to remove the film.
• Place the used camera in the
5
Kodak recycle bin.
• Visit our Web site at http://
www.kodak.com/go/kes for details
about Kodak's recycling program.
• Call Kodak's advertising distribution
center at (800) 847-8755 to order
a Kodak hand-opening tool.
Opening Instructions for the
KODAK Zoom One-Time-Use Camera
Wear eye protection when opening all cameras.
shutter button
0
thumbwheel
2
Insert Tool
• Insert the special tool into the end slot.
4
Remove Film
Opened camera
with film removed.
CAUTION: Before you attempt the
opening tasks, make sure the tool is
fully engaged with the camera body to
prevent tool slippage.
CAUTION: This camera body contains
a high-voltage capacitor and circuit
board. To avoid electric shock, do not
pry apart the front and back sections
of the camera. Remove only the film
from its respective compartment. If
sections of the camera are separated,
do not touch the circuit board.
© Eastman Kodak Company, 2004
Exposed
Film