B P R , Vga60/525P, Blackboard; Fan Control; Lamp Power; Lamp Run Time - Panasonic PT-L735NTU Operating Instructions Manual

RGB/YP P
B
This setting is valid when 750p,
HDTV60, HDTV50, 525p, 625i and
525i signals are being input. Select
the setting in accordance with the
input signal.
The RGB/YP P
B
when the RGB1 IN or RGB2 IN
connector has a signal being input.
VGA60/525P
When a VGA60 or 525p RGB signal
is being input, select the signal in
accordance with the input signal.
BLACKBOARD
Set to "ON" when PICTURE MODE
is set to BLACKBOARD. (Refer to
page 37.)

BACK COLOR

This sets the color which is
projected onto the screen when no
signal is being input to the projector.
FRONT/REAR
This setting should be changed in
accordance with the projector
setting-up method.
Set to "FRONT" when using a
normal reflective screen with the
projector positioned in front of the
screen, and set to "REAR" when
using a translucent screen with the
projector positioned behind the
screen.
DESK/CEILING
This setting should be changed in
accordance with the projector
setting-up method.
Set to "DESK" when setting up the
projector on a desk or similar, and
set to "CEILING" when suspending
the projector from the ceiling using
the ceiling bracket which is sold
separately.
46-E
NGLISH
R
item is displayed
R

FAN CONTROL

Set FAN CONTROL to "HIGH",
when using this projector at high
elevations (above 1 400 m) only.

LAMP POWER

This setting changes the lamp
brightness. When set to "LOW", the
luminance of the lamp is reduced, but
the projector uses less power, and
the operating noise is also reduced.
This can help to extend the lamp's
operating life. If using the projector in
small rooms where high luminance is
not required, it is recommended that
you set the LAMP POWER to "LOW".

LAMP RUN TIME

This setting displays the usage time
for the lamp unit which is currently
being used.
NOTE:
B The lamp's operating life varies
depending on the usage
conditions (such as the LAMP
POWER setting and the number
of times the power is turned on
and off).
FUNC 1
This assigns a function to the FUNC1
button of the remote control unit .
MUTE
Functions in the same way as the
MUTE function. (page 44)
KEYSTONE
Functions in the same way as when
"KEYSTONE" is selected from the
POSITION menu screen. (page 41)