Acer Veriton D461 Service Manual page 49

The following table describes the parameters found in this menu.
Parameter
Init Display
First
Reset
Configuration
Data
Resources
Controlled By
IRQ Resources When resource are controlled by manually, assign
PCI/VGA
Palette Snoop
Maximum
Payload Size
PCI 1/2 IRQ
Assignment
Description
Initialize the AGP video display before initializing
any other display device on the system. Thus the
AGP display becomes the primary display.
Normally, you leave this field Disabled. Select
Enabled to reset Extended System Configuration
Data (ESCD) when you exit Setup if you have
installed a new add-on and the system
reconfiguration has caused such a serious conflict
that the operating system cannot boot
This item allows user to assign PnP resource (I/O
address, IRQ&DMA channels) for Plug and Play
compatible devices automatically or manually
each system interrupt a type , depending on the type
of device using the interrupt.
Option:
[PCI Device]: Assign this IRQ for PCI device.
[Reserved]: Reserve this IRQ for other device.
This option is only very rarely needed. It should be
left at "Disabled" unless a video device specifically
requires the setting enabled upon installation.
This field displays maximum payload size of the
system
This item allows user to assign PCI IRQ for device
Options
[Enabled],
[Disabled]
[Auto]
[Manual]
[Press Enter]
[Disabled],
[Enabled]
[128-4096]
[Auto], [3] ,
[4] , [5] , [6] ,
[7], [10] ,
[11] , [12] ,
[14] , [15]
43