System Connections - Nextar X3-03 - Automotive GPS Receiver Hardware Manual

System Connections

Inserting SD Card
The unit is designed with an SD Card slot which allows you to insert an SD card into the
unit as shown below:
To remove the card, gently press the card in with your fingernail. The card unlocks and
protrudes slightly. You can now remove the card. To re-insert the card, press the card in
the slot until it clicks. The card should not protrude from the slot when it is installed
correctly.
Important:
If you remove the SD Mapping Data Card to use the Music or Photo
functions, treat the Mapping Card very carefully to avoid damage or loss of
data.
Connecting to Earphones
You may connect earphones to the right side of the unit for private listening.
When earphones are connected, the speaker will automatically turn off.
•
Note: Overly loud volume could damage your hearing. Turn down the volume
before you connect the earphones, and then raise the volume to a comfortable
level.
•
Important: Most state and local laws prohibit the driver from wearing earphones
while operating a vehicle on public roads.
9