Table of Contents
Advertisement
Operating Instructions
Problem
Water is not running.
The fault code E10 ap-
pears. The display
+Á (RINSE+) flashes.
The washing machine
vibrates during opera-
tion or it is on an une-
ven surface.
The washing solution
of the main wash
froths up a lot.
32
Possible Cause
Water valve closed.
Filter in screw connection of
the intake hose blocked.
Water tap is blocked with
limescale or is faulty.
The transport packaging has
not been removed.
The height-adjustable screw
feet are not correctly set.
There is not much washing in
the drum (e.g. only one
dressing gown).
The water could not be com-
pletely pumped off before
spinning because
The drainage hose is bent or
The solution pump is
blokked.
Too much detergent was
probably used
Remedy
Open the water valve.
Close the water valve. Un-
screw the hose from the tap,
remove the sieve and clean
under running water
Check water tap and have it
repaired if necessary.
Remove transport packaging
according to the installation
and connection instructions.
Adjust the feet according to
the installation and connec-
tion instructions.
This does not impair the op-
eration of the machine.
Check the laying of the
drainage hose and eliminate
the bend if necessary, or
clean the solution pump and,
if required, remove foreign
bodies from the pump hous-
ing.
Meter the detergent exactly
in accordance with the man-
ufacturer's information.
Hide quick links:
Advertisement
Table of Contents
