Accessing Your Router After Installation And Checking For New Firmware - NETGEAR WNR3500v1 - RangeMax Wireless N Gigabit Router Setup Manual

you can always access the router's user interface later to select a security option (see
"Accessing Your Router After Installation and Checking for New
To ensure optimum performance of your high-speed wireless router, the
wireless adapter card for each computer in your network should support the
same technology as your router (see the online User Manual for more
information).
You are now connected to the Internet!
To set up additional wireless computers in your network to access the router and connect to the
Internet, see "Setting Up Your Wireless Computers" on page
Accessing Your Router After Installation and
Checking for New Firmware
The Smart Wizard only appears when you first install the router or when the router is in its factory
default state (for example, if you have reset the router to its factory default settings). If you want to
change the settings after installing and configuring your router using the Smart Wizard, you must
open a browser window and log in to the router. You will also be prompted to check for new router
firmware.
To log in to the router after installation:
1. Open a browser window and type http://www.routerlogin.net in the address field of your
browser. Press Enter.
You can enter either of these addresses to connect to your wireless router:
http://www.routerlogin.net or http://www.routerlogin.com.
A login window similar to the one shown below will display.
10
Firmware").
26.
Installing Your Router Using the Smart Wizard