Replacing Battery; Interlocks And Relays; To Replace Fuse; To Remove Hood And Grill Assembly - Craftsman 28925 - YT 4000 24 HP/42" Yard Tractor Operation Manual

REPLACING BATTERY
_IbWARNING: Do not short ter-
battery
minals by allowing a wrench or any other
object to contact both terminals at the same
time. Before connecting battery, remove
metal bracelets, wristwatch bands, rings, etc.
Positive terminal must be connected
first to prevent sparking from accidental
grounding.
1. Lift seat pan to raised position.
2. Disconnect BLACK battery cable first
then RED battery cable and carefully
remove battery from tractor.
3. Install new batterywithterminals in same
position as old battery.
4. First connect RED battery cable to posi-
tive (+) terminal with hex bolt and keps
nut as shown. Tighten securely. Slide
terminal cover over terminal
5. Connect BLACK grounding cable to
negative (-) terminal with remaining hex
bolt and keps nut. Tighten securely.
(_ Negative
"_ (Black)
. _ Cable
INTERLOCKS AND RELAYS
Loose or damaged wiring may cause your
tractor to run poorly, stop running, or prevent
it from starting.
• Check wiring. See electrical wiring dia-
gram in the Repair Parts section.
TO REPLACE FUSE
Replace with 30 amp automotive-type plug-in
fuse.Thefuseholderislocatedbehindthedash.
TO REMOVE HOOD AND GRILL
ASSEMBLY
,
2.
3.
.
Raise hood.
Unsnap headlight wire connector.
Stand in front of tractor. Grasp hood at
sides tilttoward engine and lift off oftractor.
When replacing hood, ensure to recon-
nect the headlight wire connector.
Hood
HeadLight Wire
Connector
Positive
(Red)
Cable
TO REPLACE HEADLIGHT BULB
1. Raise hood.
2. Remove bulb holder from the hole in the
backside of the grill.
3. Replace bulb in holder and install bulb
holder securely back into the hole in the
backside of the grill.
4. Close hood.
ENGINE
TOADJUSTTHROTTLECONTROLCABLE
The throttle control has been preset at
the factory and adjustment should not be
necessary Check adjustment as described
below before loosening cable. If adjustment
is necessary, see engine manual.
TO ADJUST CHOKE CONTROL
The choke control has been preset at the
factory and adjustment should not be neces-
sary. If adjustment is necessary, see engine
manual.
TO ADJUST CARBURETOR
Your carburetor has been preset at the factory
and adjustment should not be necessary.
However, minor adjustment may be required
to compensate for differences in fuel, tem-
perature, altitude or load. Ifthe engine does
need adjustment, see engine manual.
26