System Information; Rearview Camera; Rearview Camera Brightness Adjustment - Acura 2009 TSX Navigation Manual

Hide thumbs Also See for 2009 TSX:
Table of Contents

Advertisement

System Setup

System Information

From the SETUP screen (Other), say
or select System Information and the
following screen appears:
Displays the information on the
navigation system software. This
information is for dealer use only. For
ordering updates, use the version
number stamped on the label (as Ver.
X.XX) of the navigation DVD. See
Obtaining a Navigation Update DVD on
page 124.
When finished, say or select Return to
return to the previous screen.
116 Navigation System

Rearview Camera

Your vehicle is equipped with a
rearview camera as shown in the
illustration.
Whenever you shift to R (Reverse) with
the ignition switch in the ON (II)
position, the rear view is shown on the
navigation screen. For the best image,
always keep the rearview camera lens
clean, and be sure it is not covered.
Since the rearview camera display area
is limited, you should always back up
slowly and carefully, and look behind
you for obstacles.
Rearview Camera Brightness
Adjustment
When in reverse, the navigation "hard"
buttons are locked out, except the
rotating portion of the Interface Dial
(knob). Rotate the knob clockwise to
make the camera image brighter, and
counterclockwise to darken the image.
Rearview
This brightness adjustment is
Camera
independent of the screen brightness
adjustment in SETUP.
NOTE:
• The camera brightness cannot be
adjusted by voice control.
• Slight delays can occur when
switching to the camera image, or
switching back to the map/menu
screen. This is normal.

Advertisement

Table of Contents
loading

Table of Contents