Table of Contents
Advertisement
Eject Button
Label on the top surface, and
insert the shutter-side headfirst.
Information for Windows XP
<Only for CF-50A******/CF-50B******>
8
Create Backup Disks for reinstallation
Prepare 2HD floppy disks and make sure they are not in the write-protected state, and
1
then set it.
Windows 2000
2
Select [Start] - [Programs] - [Panasonic] - [Create Backup Disk] and follow the on-
screen instructions.
Windows XP
Select [start] - [All Programs] - [Panasonic] - [Create Backup Disk] and follow the on-
screen instructions.
When [You do not need to make "BACKUP DISK"] is displayed, there is no need to
create a Backup Disk.
Place a label identifying the contents on each disk.
3
Name of created backup disk
FIRSTAID FD (When the display for creating the UPDATE FD is shown, create the
disk by following the on-screen instructions.)
CAUTION
Store the floppy disks in a safe place. They will enable you to return your com-
puter to close to the condition at the time of purchase should any problems occur.
When creating backup disks, do not run any other application program.
When creating backup disks and the message [Insufficient files to copy] is dis-
played, select [OK] and then contact Panasonic Technical Support (
While the floppy disk drive indicator is on, do not remove the floppy disk, power
off your computer or use the standby or hibernation function (
Hibernation Functions").
Be sure to create the backup disk.
If a backup disk is not created, it will be impossible to return the computer to its
original state. In this case, contact Panasonic Technical Support (
This concludes the first-time use operation guidelines.
NOTE
<Information for the DVD-ROM & CD-R/RW drive>
Before using the DVD-ROM & CD-R/RW drive for the first time, remove the protective
sheet from the lens area. The protective sheet inside the drive delays the opening of the
drive by about ten seconds. This delay is not a problem.
Depending on the Windows settings, installed applications, and drivers, menus and
other displays may differ, or some functions (such as use of the password reset disk)
may be inoperable. Check with your system administrator for details.
You can select Classic view for the Control Panel or select the Classic Start menu. You
can also change the way a user logs on or off.
The procedure in this manual uses the method or view of the Windows XP default
setting (not Classic view or Classic Start menu etc.).
Resetting the password
Windows XP has a function to reset a forgotten password.
To use this function, you need to create a password reset disk beforehand following the
steps below.
1 Select [start] - [Control Panel] - [User Accounts].
2 Select [Prevent a forgotten password] from [Related Tasks] menu of the account you
used to logon and create a password reset disk following the on-screen instructions.
Store the password reset disk in a safe place.
· Only the logon password for each account can be reset.
The password set in the Setup Utility cannot be reset.
page 42).
"Standby/
page 42).
15
Advertisement
Table of Contents
