Configuring The Network Settings On The Administrative System - NETGEAR FS728TPv2 Software Administration Manual

You must enter the current password every time you use the Smart
Tip:
Control Center to update the switch setting. The default password is
password.
Click Apply to configure the switch with the network settings.
9.
Please ensure that your PC and the switch are in the same subnet. Make a note of these
settings for later use.
Configuring the Network Settings on the Administrative
System
If you choose not to use the Smart Control Center to configure the network information on the
switch, you can connect directly to the switch from an administrative system, such as a PC or
laptop computer. The IP address of the administrative system must be in the same subnet as
the default IP address on the switch. For most networks, this means you must change the IP
address of the administrative system to be on the same subnet as the default IP address of
the switch (192.168.0.239).
To change the IP address on an administrative system running a Microsoft
operating system, open the Internet Protocol (TCP/IP) properties screen that you access
from the Local Area Connection properties, as shown in the following figure. You need
Windows Administrator privileges to change these settings.
16 | Chapter 1: Getting Started
FS728TP Smart Switch Software Administration Manual
® ®
Windows