Advertisement
Digital Sound Projector™ Technology
Digital Sound Projector™ Technology
The YSP components apply sophisticated Digital
Sound Projector™ Technology to precisely control
the orientation of the sound by focusing it into
beams. The center channel sound is heard directly,
while sounds from other channels are heard after
reflecting off walls. The result is true multi-channel
surround sound that sounds
just like a multi-speaker
system — but without the
need for extra speakers!
Multiple channels are superimposed to create the sound. In a
5.1-channel configuration, the beam speakers together create the
sound of 5.1 superimposed channels.
Digital Amplifier Built-in
The YSP components have a powerful and efficient
digital amplifier built in. There is no need for you to
IntelliBeam Automated System Calibration
Wide Variety of Beam Settings
5-Beam
4
Delay Control
Digital Amplifiers
Speaker Array
Sound is projected at the listener from five directions: straight ahead, reflected off one wall, and reflected off two walls (so it is heard from the rear).
Aiming of Sound Beam
purchase an additional amplifier or receiver, so the
system is compact and economical.
TV monitor
Yamaha YSP (no need
additional amp/receiver) vs.
other system
IntelliBeam Automated System Calibration
This Yamaha exclusive feature ensures optimum
multi-channel sound reproduction with accurate
image location. By monitoring and analyzing the
3 Beam
3-Beam + Stereo
TV monitor
Conventional
Speaker
Amp/Receiver
Left: Each sound beam
is precisely directed.
Center: Total sound
beam effect is
optimized. Right:
Sound is monitored
and analyzed, after
which frequency
response and other
parameters are
optimized for the
room.
2ch Stereo
5ch Stereo
sound with the microphone
included with the YSP
components, IntelliBeam
automatically sets the best
beam angles and modes,
while optimizing the level and frequency response
of each beam. This makes initial setup both
extremely simple while acoustically perfect. Manual
setup is also possible.
Wide Variety of Beam Settings
My Surround mode provides surround sound
without reflecting the beams off the walls. It is
handy for rooms where for some reason the walls
can not be used well and delivers a good surround
effect when listeners are close to the unit.
My Beam setting focuses the sound at a
specific listening position, so even in noisy
surroundings you can hear dialogue and other
sounds clearly. A sonic sensor allows you to select
My Beam with the remote control from almost any
angle. There are also five other selectable beam
settings: 5 Beam, 3 Beam, 3 Beam + Stereo,
2ch Stereo and 5ch Stereo that outputs stereo
sources from all of the 5-channel beams, providing
a more expansive sound field.
My Surround
My Beam
Advertisement
