Appendix; Transceiver, Chassis Connectors, And Cable And Adapter Specifications; Transceiver Support For Uplink Ports; 1-Gb Sfp Transceivers - Cisco 4948 - Catalyst Switch Installation Manual

Transceiver, Chassis Connectors, and Cable and
Adapter Specifications
Revised: January 4, 2012
This appendix covers the transceivers supported by the Catalyst 4948E and the Catalyst 4948E-F
switches, the connectors on the front panel of the chassis, and the cables and adapters supplied in the
accessory kit. The appendix is divided into the following topics:
•
•
•
•
For additional information about the Cisco Catalyst 4948E and the Catalyst 4948E-F switches (including
Tip
configuration examples and troubleshooting information), see the documents listed on this page:
http://www.cisco.com/en/US/products/ps6021/tsd_products_support_series_home.html

Transceiver Support for Uplink Ports

Both the Catalyst 4948E and the Catalyst 4948E-F chassis have four uplink ports that support both 1-GB
SFP and 10-GB SFP+ transceivers.

1-GB SFP Transceivers

Table B-1
Table B-1
SFP
Transceiver
GLC-T
GLC-SX-MM
OL-21561-02
Transceiver Support for Uplink Ports, page B-1
Console Port, page B-11
Ethernet Management Port, page B-12
Cables and Adapters, page B-12
lists the 1-GB SFP transceivers that are supported on the chassis uplink ports.
1-GB SFP Transceiver Support
Description
(1000BASE-T)
(1000BASE-SX)
A P P E N D I X
Catalyst 4948E an Catalyst 4948E-F Switch Installation Guide
B
B-1