Before You Start; Workstation Connections; Twisted Pair (Tp) Cables; Hub Connections - 3Com 3C16753 - OfficeConnect Dual Speed Hub 8 User Manual

Before You Start

Your OfficeConnect hub comes with:
One power adapter for use with the OfficeConnect hub.
A Product Registration card for you to fill out and return.
Four rubber feet.
A stacking clip.
The extra parts mentioned in the next section are not
supplied with the hub.

Workstation Connections

To connect workstations or other equipment to your hub,
you need:
One 10BASE-T,
1
10/100BASE-TX, or
100BASE-TX adapter card
for each workstation. 3Com
produce a range of
easy-to-install network
adapter cards, which
provide your workstations with a suitable connection.
2 An operating system (for example, Netware or Windows
95/98) with network support configured, running on
your workstations.
One suitable TP cable for each workstation.
3
In order to comply with the 10BASE-T standard, ports
designed for workstation connections have been
marked with the graphical symbol 'x'. This denotes a
crossover in the port's internal wiring, for example 1x,
2x, 3x...

Twisted Pair (TP) Cables

To connect your workstations and other equipment to the
Hub, use 'straight-through' TP cables with RJ-45 connectors
(all OfficeConnect products use RJ-45 type connectors). A
'straight-through' cable is one where each pin of one
connector is connected to the same pin of the other
connector. Cables can be shielded (screened) or unshielded;
we recommend that you use shielded cable. Cables used for
100BASE-TX or 10/100BASE-TX connections must be data
grade (Category 5). Your supplier should stock suitable
cables.
The maximum length of a single cable is 100m (328ft).
3
Refer to "Fast Ethernet (100Mbps) Configuration Rules" on
page 13 for further information on cable lengths in a
2
100Mbps network.
1

Hub Connections

To connect other OfficeConnect units to your Hub, you
need one suitable TP cable for each unit.
10