What To Do, When - AEG FAVORIT 44450 Instruction Book

152963010en per uk.qxp

What to do, when...

Certain problems are due to the lack of simple maintenance or
oversights, which can be solved with the help of the instructions given
here, without calling out an engineer.
...a flashing fault code appears
The dishwasher will not start or stops during operation. All buttons are
inoperative except for the On/Off button and a combination of
indicator lights, as indicated in the following chart, are flashing. Open
the dishwasher's door and carry out the following suggested corrective
actions.
Fault code / Malfunction
- Indicator light of the
programme in progress
is flashing.
- 1 flash of the indicator
light "End of
programme".
The machine does not fill
with water
- Indicator light of the
programme in progress
is flashing.
- 2 flashes of the
indicator light "End of
programme".
The dishwasher will not
drain
- Indicator light of the
programme in progress
is flashing.
- 3 flashes of the
indicator light "End of
programme".
25/03/2004 15.31 Pagina 33
Possible cause
The water tap is blocked or
furred with limescale.
The water tap is turned off.
The filter (where present) in
the threaded hose fitting at
the water inlet valve is
blocked.
The water inlet hose has not
been correctly laid or it is
bent or squashed.
The sink spigot is blocked.
The water drain hose has not
been correctly laid or it is
bent or squashed.
Protection against flooding is
active.
Operating instructions
Solutions
Clean the water tap.
Turn the water tap on.
Clean the filter in the
threaded hose fitting.
Check the water inlet hose
connection.
Clean out the sink spigot.
Check the water drain
hose connection.
Close the water tap and
contact the Service Force
Centre.
33