Display Bezel; Installing The Display Assembly; Removing The Display Bezel - Dell 610D Service Manual

8. Lift the display assembly up and out of the computer base.

Installing the Display Assembly

1. Align the display assembly over the screw holes in the base of the computer.
2. Tighten the four M2.5 x 5-mm screws.
3. Route the two antenna cables under the routing clips.
NOTE: Ensure that you route the antenna cables under the routing clips. Failure to do so could result in your keyboard not seating properly.
4. Replace the keyboard (see
5. Replace the center control cover (see
Display Bezel
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide.
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such
as the back panel) on the computer.

Removing the Display Bezel

1. Follow the instructions in "Preparing to Work Inside the
2. Remove the center control cover (see
3. Remove the keyboard (see
4. Remove the display assembly (see
5. Use a plastic scribe tool to pry the six display bumpers out of the screw holes located on the front of the bezel.
"Installing the Keyboard").
"Installing the Center Control
Computer."
"Removing the Center Control
"Removing the Keyboard").
"Removing the Display Assembly").
Cover").
Cover").