What To Do If - Electrolux EHS 60020 K User Manual

What to do if ...

Problem
The cooking zones are not
functioning.
The cooking zones cannot be
selected / Appliance does not
react to the control panel input
The residual heat indicator is
not displaying anything
Er03
is displayed
Er21
is displayed
Er25
is displayed
(only for 10 seconds)
Er40
is displayed
Possible cause
No cooking zone selected
More than 10 seconds has
passed since the appliance
was switched on
The child safety device is acti-
vated
The sensor fields are partly
covered by a damp cloth or
with liquid
Safety cut-out has been trig-
gered
The cooking zone was only on
for a short time and is therefore
not hot
Several sensor fields were
touched at the same time
Safety cut-out due to over-
heating.
Appliance is incorrectly con-
nected
The overvoltage protector has
been activated (for an incor-
rect connection see above
Er25
or for overheating of the
electronic components see
Er21
)
what to do if ... electrolux 17
Remedy
Select cooking zone within 10
seconds of switching on (Dec-
imal point lights up)
Switch on the appliance again.
Select cooking zone within 10
seconds of switching on
Deactivate the child safety de-
vice (See section "Child safety
device")
Remove the cloth or the liquid
Switch on the appliance again
If the cooking zone is sup-
posed to be hot, call your local
Service Force Centre.
Only touch one sensor field
Let the appliance cool down.
Remove cookware.
Disconnect the appliance from
the electrical supply and have
it connected properly
Separate the appliance from
the mains for a few minutes
(remove the mains fuse).
Let the appliance cool down.