Haier LY22K3CWW2 User Manual page 14

About your LCD TV About your LCD TV / Getting Started
B
Press the button to select SCART mode.
SOURCE
C
Press the PLAY button on the external device.
HDMI INPUT
A
Connect the cable from the HDMI device to the TV
HDMI socket.
B
Press the SOURCE button to select HDMI mode.
C
Refer to the HDMI device user guide for how to
operate.
MOUNT YOUR TV ONTO THE WALL
You can mount your TV onto the wall by using a wall
bracket (not supplied). Use M4/M6 machine screws (4
pcs) to screw the TV onto the bracket (not supplied).
PREPARATION OF
YOUR REMOTE
CONTROL
BATTERY INSTALLATION
A
Place the remote control face down, then open the
cover of the battery compartment.
B
Install two AAA batteries. (The + and - symbol of the
battery must match with the marks on the remote).
EN-13 Digital LCD Television Instruction Manual
C
Close the cover of the battery compartment.
BATTERY CAUTION
Confirm there is no object between the remote control
and the remote sensor of the TV set.
Sunshine or other strong light will interfere with the
signal sent by the remote control. In this situation turn
the TV set to avoid the direct light source.
Do not put the remote control in direct heat or in a damp
place as you may damage the remote.
Please use two AAA 1.5V batteries. Do not mix battery
types. Install the batteries at the correct polarities. Do not
use rechargeable batteries. If your TV is to be stored for
a period of time, remove the batteries from the remote
control.
03 Getting
Started
Setting up
LOCATION
You will need to place your TV near your plug socket (so
the power cable can comfortably reach) and within reach
of your aerial socket or extension lead.
CONNECTION
A
Insert your TV aerial lead into the Antenna input at
the side of the TV.