Installation Procedures - HP ProLiant DL590/64 Manual

Deployment of Red Hat Linux 7.2 for Itanium™ Processor on ProLiant DL590/64 Servers
Table 3. Supported Compaq network interface controllers (continued)
Compaq NIC
Compaq NC3135 Fast Ethernet Module Dual
(10/100 Upgrade Module for NC3134 and
NC3131)
Compaq NC6132 Gigabit Upgrade Module
(1000 SX Upgrade Module for NC3134 and
NC3131)
Compaq NC6133 Gigabit Module (1000 LX
Upgrade Module for NC3134 and NC3131)
Compaq NC3133 Fast Ethernet Module (100FX
Upgrade Module for NC3134 and NC3131)
Compaq NC6136 Gigabit Server Adapter, 64-
bit/66MHz, PCI, 1000 SX
Compaq NC7131 Gigabit Server Adapter, 64-
bit/66MHz, PCI, 10/100/1000-T
Compaq NC7132 10/100/1000-T Upgrade
Module for NC3134 and NC3131

Installation Procedures

To install Red Hat Linux 7.2 for Itanium Processor on the ProLiant DL590/64 so that it is fully
supported by Compaq and Red Hat, first read the following sequence of steps completely and
then follow them carefully.
Pre-Installation Checks
1. Verify the completeness and correctness of your hardware configuration before powering on
your system.
a. Make sure that you are using only supported storage options (see Table 2).
b. Confirm that you are using only supported network interface controllers (see Table 3).
c. Ensure that you have not installed any memory that was not provided for use with
Itanium-based platforms.
d. Make certain that you have installed some type of disk storage (not included with the
system), either on the internal storage bays or as external storage.
e. Confirm that you have cabled the system correctly, according to instructions included
with the ProLiant DL590/64 Setup and Installation Guide (included with the server).
f. Run the Compaq ROM-Based Setup Utility (RBSU) and set the OS type to Linux.
Configuration Selections
2. Insert the first Red Hat Linux 7.2 for Itanium Processor CD in the CD-ROM drive of the
server. Boot the system.
3. Select your language preference. This language choice will be used on the screen throughout
the installation setup. Click Next.
4. Select your keyboard and layout, and then click Next.
16S6-0502A-WWEN
Driver Location
e100 Red Hat CD
e1000 Red Hat CD
e1000 Red Hat CD
e100 Red Hat CD
e1000 Red Hat CD
e1000 Red Hat CD
e1000 Red Hat CD
6