Boot Options; Operating System Installation - HP ProLiant DL360e User Manual

Table 2 RBSU settings on Gen8 servers with Intel processors (continued)
RBSU
nl
power management options
"Minimum Processor Idle
Power Package State"
(page 51)
"Energy/Performance Bias"
(page 53)
"Maximum Memory Bus
Frequency" (page 54)
"Channel Interleaving"
(page 55)
"Maximum PCI Express
Speed" (page 59)
"DIMM Voltage Preference"
(page 64)

Boot options

Near the end of the boot process, the boot options screen is displayed. This screen is visible for
several seconds before the system attempts to boot from a supported boot device. During this time,
you can press the following keys:
Key
F9
F10
F12

Operating System Installation

For an assisted operating system installation:
In Gen8 environments, boot the server and press F10 when prompted to open the Intelligent
Provisioning tool.
In G7 environments, insert the SmartStart CD into the CD-ROM drive to begin the installation
process. The operating system and server support software are installed upon completion of
this process.
For a manual OS installation, insert the operating system CD into the CD-ROM to begin the
installation process.
194 ROM-based utilities
Intelligent Provisioning Quick Configs settings
Balanced power and
performance
Package C6 (retention) State
Balanced Performance
Auto
Enabled
Maximum Supported
Optimized for Performance
Action
Access RBSU.
In Gen8 systems: Access Intelligent Provisioning.
nl
In G7 systems: Access the System Maintenance Menu, which enables you to launch
ROM-based Diagnostics or Inspect.
Force a PXE Network boot.
Minimum power usage
Package C6 (retention) State
Power Savings Mode
800MHz
Disabled
PCIe Generation 1
Optimized for Power
Maximum performance
No Package State
Maximum Performance
Auto
Enabled
Maximum Supported
Optimized for Performance