Sony CDX-GT472UM Operating Instructions Manual page 16

S.WOOFER*
SW LEVEL (Subwoofer Level)
Adjusts the subwoofer volume level:
"+10 dB" – "0 dB" – "–10 dB."
("ATT" is displayed at the lowest
setting.)
SW PHASE (Subwoofer Phase)
Selects the subwoofer phase: "NORM,"
"REV."
SW POS*
Selects the subwoofer position: "NEAR,"
"NORMAL," "FAR. "
LPF FREQ (Low Pass Filter Frequency)
Selects the subwoofer cut-off frequency:
"50Hz," "60Hz," "80Hz," "100Hz,"
"120Hz."
LPF SLOP (Low Pass Filter Slope)
Selects the LPF slope: "1," "2," "3."
HPF (High Pass Filter)
HPF FREQ (High Pass Filter Frequency)
Selects the front/rear speaker cut-off
frequency: "OFF," "50Hz," "60Hz,"
"80Hz," "100Hz," "120Hz."
HPF SLOP (High Pass Filter Slope)
Selects the HPF slope (effective only
when HPF FREQ is set to other than
"OFF"): "1," "2," "3."
AUX VOL* (AUX Volume level)
6
Adjusts the volume level for each
connected auxiliary equipment:
"+18 dB" – "0 dB" – "–8 dB."
This setting negates the need to adjust
the volume level between sources.
*1 Does not appear when "SET F/R POS" is set to
"OFF."
*2 When the audio output is set to "SUB-OUT"
(page 15).
*3 Does not appear when the tuner is selected.
*4 When the audio output is set to "REAR-
OUT" and "SW DIREC" is set to "OFF."
*5 When the audio output is set to "REAR-
OUT" and "RBE MODE" is set to "OFF."
*6 When the AUX is selected.
16
(Subwoofer)
2
(Subwoofer Position)
1
DISPLAY:
DEMO (Demonstration)
Activates the demonstration: "ON,"
"OFF."
DIMMER
Changes the display brightness: "ON,"
"OFF."
AUTO SCR* (Auto Scroll)
Scrolls long items automatically: "ON,"
"OFF."
M.DISPLAY (Motion Display)
– "SA": to show moving patterns and
spectrum analyzer.
– "OFF": to deactivate the Motion Display.
* When the CD or USB is selected.