Brother KE-436C Instruction Manual page 24

(10) Bobbin Thread COUNTER..... Illuminates when bobbin thread counter mode has been selected using the menu switch
indicator
(11) SPLIT NO. indicator............... Illuminates when split No. mode has been selected using the menu switch (6).
(12) Dial ........................................ The setting shown on the display screen (5) can be changed by turning this dial while
(13) Bobbin Thread SET switch. ... Used to store the number of work pieces displayed in the bobbin thread counter to floppy
(14) Bobbin Thread CHANGE ....... Used to continue sewing after replacing the bobbin thread.
switch
(15) TEST switch...........................Used to move the feed mechanism only in order to confirm a programmed stitch pattern.
(16) TEST indicator ....................... Lights when the TEST switch is pressed.
(17) STEP BACK switch................ Used when winding a fresh bobbin, or when correcting a stitch pattern due to a broken
(RESET switch)
(6).
pressing the STEP BACK switch (17).
disk.
(An alarm will sound when the counter reads <000>. Sewing is not possible when the
counter reads <000>.) (Refer to "5-9. Using the bobbin thread counter".)
needle thread.
Also used to reset error displays.
KE-436C
5. USING THE OPERATION PANEL
2688Q
18