5.
Insert the Red Hat
OK, then press <Enter>.
Insert your driver disk into /dev/fd0
and press "OK" to continue.
The drivers for the RAID controller are installed to the system.
When asked if you will load additional RAID controller drivers, select No, then
6.
press <Enter>.
Do you wish to load any more
driver disks?
7.
Follow the onscreen instructions to finish the OS installation.
8.
When the installation is completed, DO NOT click Reboot. Press <Ctrl>
+ <Alt> + <F2> to switch to the command-line interface from graphic user
interface.
9.
Type the following commands when using a Legacy floppy.
mkdir /mnt/driver
mount /dev/fd0 /mnt/driver
cd /mnt/driver
sh replace_ahci.sh
reboot
6-10
Enterprise RAID driver disk to the floppy disk drive, select
®
Insert Driver Disk
OK
More Driver Disks?
Yes
No
Back
Chapter 6: Driver installation