Errata - Intel D915PSY Specification

®
Intel Desktop Board D915PSY Specification Update

ERRATA

1. Wake On LAN May Not Function After Loss and Restore
of AC Power
P :
If AC power is removed, Wake On LAN may not function until the LAN circuit is re-
ROBLEM
initialized. The sequence of events is as follows:
• AC power removed (AC power cord disconnected, for example)
• AC power restored. +5V Standby voltage is re-applied to the board
• Wake On LAN may not be functional
• Switch power on
• Switch power off to put system back into Standby mode (S5 state)
• Wake On LAN functionality restored
I :
Wake on LAN will not function if AC power is interrupted.
MPLICATION
W :
In the BIOS Setup program, set After Power Failure to "Power On" in the
ORKAROUND
Power Menu.
S :
This erratum may be fixed in a future BIOS revision.
TATUS
2. The placement of capacitors behind the PCI Express* x1
connector slot may prohibit some PCI Express x1 add-in
cards from properly connecting to the motherboard.
P :
Due to the design and placement of the audio circuitry on this motherboard, it was necessary to
ROBLEM
position capacitors in the keep-out zone behind the PCI Express* x1 connector slot.
I :
Some PCI Express x1 add-in cards may not fully connect to the PCI Express x1 connector slot,
MPLICATION
due to interference between capacitors in the keep-out zone and I/O connectors on the add-in card that are
located on the I/O bracket, in line with the edge fingers on the card.
W :
None
ORKAROUND
S : M
TATUS AY BE FIXED IN A LATER HARDWARE REVISION
6
.