Table of Contents
Advertisement
11. Press down the fan and air tunnel
assembly until the side rails slide
past the grooves and over the rail
stoppers. The protruding tab on
each corner of the air tunnel
should snap over the dents on the
retention mechanism.
12. Connect the fan cable to the
connector CPU_FAN1 on the
motherboard.
Make sure to connect to the
correct fan connector.
Otherwise, you will get a
warning message during
POST.
13. To install a second CPU and heatsink, follow the same procedure as in
the first CPU installation.
For the second CPU, make sure to connect the CPU fan cable to the
connector CPU_FAN2.
2-12
Rail stopper
Side rail
Chapter 2: Hardware information
Protruding tabs
Fan connector
Fan cable
Advertisement
Table of Contents
