Bios Configuration Jumper; Front Panel Audio Header/Jumper Block; Jumper Settings For The Bios Setup Program Modes - Intel D201GLY2A - Desktop Board Motherboard Product Manual

Intel Desktop Board D201GLY2 Product Guide
Table 7 describes the two configurations of this header/jumper block.
Table 7. Front Panel Audio Header/Jumper Block
Jumper
Setting
NOTE
When the jumpers are removed and this header is used for front panel audio, the back
panel audio line out and mic-in connectors are disabled.

BIOS Configuration Jumper

The three-pin BIOS jumper block enables all board configuration to be done in the
BIOS Setup program. Table 8 shows the jumper settings for the Setup program
modes.
Figure 14, B shows the location of the Desktop Board's BIOS configuration jumper
block.
Table 8. Jumper Settings for the BIOS Setup Program Modes
Jumper
Setting
38
Configuration
5 and 6 Audio line out and mic-in signals are routed to the back panel
connectors. The back panel audio connectors are shown in
Figure 2.
9 and 10
No Table 4 lists the names of the signals available on this connector
jumpers when no jumpers are installed.
installed
Mode
Normal (default) (1-2)
Configure (2-3)
Recovery (None)
Description
The BIOS uses the current configuration and
passwords for booting.
After the Power-On Self-Test (POST) runs, the
BIOS displays the Maintenance Menu. Use this
menu to clear passwords.
The BIOS recovers data from a recovery diskette
in the event of a failed BIOS update.