Power Supply Installation - HP D7171A - NetServer - LPr Installation Manual

Chapter 2
Push the cage in all the way. Bring the small, black middle connector
up through the slot in the board above the power supply cage until the
connector "clicks" and the plastic lock is in place. Check to make sure
that the connector is secure. See Figure 2-3.
First, attach the two large, white
connectors.
Then, attach the small, black
connector.
Figure 2-3. Attaching the Power Supply Connectors
7. Fasten the cage in place with one screw on the side, lower rear. Fasten
the two screws into the rear chassis.
8. Reinstall the fan module.

Power Supply Installation

To install a power supply module (PSM) in the empty power supply cage, follow
these steps:
CAUTION
When lifting a PSM, be prepared to support its weight. Hold
the PSM with two hands.
12
Cage and Power Supply Installation