Chapter 1
l
Technical Reference Card which fits into an envelope inside the chassis
l
HP NetServer Navigator CD-ROM
l
HP NetServer Online Documentation CD-ROM
l
Power Supply module
Determine Which Accessories You Need
Use the guidelines described in this section when purchasing additional
accessories for your new HP NetServer LH 6000/6000r.
Power Supply Upgrade Kit
You must order a Power Supply Upgrade Kit, product number D8551A, for the
HP NetServer LH 3000/3000r and LH 6000/6000r.
WARNING
Do not proceed with this upgrade without first purchasing the
appropriate Power Supply Upgrade Kit. The HP NetServer
LH 6000/6000r cannot operate without a minimum of three
power supplies.
Memory
The upgrade kit comes with two 128-MB DIMMs. You can use 128-MB,
256-MB, 512-MB, and 1-GB SDRAM DIMMs. Note the following installation
guidelines before adding memory:
l
DIMMs are installed in pairs on the system board.
l
Each pair of DIMMs must be of the same size.
l
You can remove DIMMs from the HP NetServer LH 3000/3000r and
install them in the new system board for the LH 6000/6000r as long as you
install them in pairs of the same capacity and type.
l
Although the two DIMMs in each pair must have the same capacity, pairs
with different capacities can be mixed on the system board. For example,
you can install a pair of 1-GB DIMMs, a pair of 128-MB DIMMs, and so
on.
l
DIMMs that differ in type cannot be mixed.
l
The maximum amount of memory for the NetServer LH 6000/6000r is
8 GB.
Introduction
3