Additional Cli Commands - HP StorageWorks 2/32 - SAN Switch Release Note

Additional CLI commands

Use cfgEnable [active_zoning_config] on the switch to update zoning
to use the new PID format. This does not change the definition of zones in the
fabric, but causes the lowest level tables in the zoning database to be updated with
the new PID format setting.
Example:
Finally, use the switchEnable command to re-enable the switch.
Once this is done on every switch in the fabric, all switches in the fabric will
operate with the new addressing mode.
Note:
SAN Design Guide and HP support services.
Additional CLI commands
portcfglongdistance
Extended links in the same SAN are either 1 Gbps or 2 Gbps, but not both. If you
have 1 Gbps extended links in the SAN you can not add a 2 Gbps Extended Link
to the same SAN.
50
Virtual Channel parameters (yes, y, no, n): [no]
Switch Operating Mode (yes, y, no, n): [no]
Zoning Operation parameters (yes, y, no, n): [no]
RSCN Transmission Mode (yes, y, no, n): [no]
Arbitrated Loop parameters (yes, y, no, n): [no]
System services (yes, y, no, n): [no]
Portlog events enable (yes, y, no, n): [no]
Committing configuration...done.
switch:admin> switchenable
switch:admin> cfgEnable myZoningCfg
For more information on upgrading to larger port count switches, refer to the HP
SAN switch 2/32 Version 4.0.2b Release Notes