Image (Toggle) Command; On Start Setting Command; On Start Cancel Command; Power Management Ready Command - Sanyo PLC-XU116 - 4500 Lumens Manual

PLC-XU116 Basic Serial Command Specifications

6.35. IMAGE (Toggle) Command

Command "C27"[CR]
Switch Image Setting status.
Detail
This command works the same way as "IMAGE" button of the remote control.
Acceptable
Response
Unacceptable

6.36. ON START Setting Command

Command "C28" [CR]
Enable Power ON Start.
Detail
This status is stored in EEPROM and retained regardless of Power OFF/ON.
Acceptable
Response
Unacceptable

6.37. ON START Cancel Command

Command "C29" [CR]
Disable Power ON Start.
Detail
This status is stored in EEPROM and retained regardless of Power OFF/ON.
Acceptable
Response
Unacceptable

6.38. Power Management Ready Command

Command "C2A" [CR]
Set Power Management to Ready mode.
Detail
This status is stored in EEPROM and retained regardless of Power ON/OFF.
Acceptable
Response
Unacceptable

6.39. Power Management OFF Command

Command "C2B" [CR]
Set Power Management to OFF mode.
Detail
This status is stored in EEPROM and retained regardless of Power ON/OFF.
Acceptable
Response
Unacceptable

6.40. Power Management Shut down Command

Command "C2E" [CR]
Set Power Management to Shut down mode.
Detail
This status is stored in EEPROM and retained regardless of Power OFF/ON.
Acceptable
Response
Unacceptable
[ACK] [CR]
"ÿ "[CR]
[ACK] [CR]
"ÿ "[CR]
[ACK] [CR]
"ÿ "[CR]
[ACK] [CR]
"ÿ "[CR]
[ACK] [CR]
"ÿ "[CR]
[ACK] [CR]
"ÿ "[CR]
17/26