Resetting The Lamp Timer - Epson RB-V11H255020-N - PowerLite 83c LCD Projector Product Information Manual

5. Use the screwdriver to loosen the two screws holding the
lamp in place. (You can't remove the screws.)
6. Hold the lamp as shown and pull it straight out.
Note:
The lamp(s) in this product contain mercury. Please
consult your state and local regulations regarding disposal or
recycling. Do not put in the trash.
7. Gently insert the new lamp along the guide rail. If it doesn't
fit easily, make sure it's facing the correct way. Push the
lamp down firmly where the label
Caution:
Do not touch the glass portion of the lamp assembly. Touching
the glass could result in premature lamp failure.
Don't remove
these screws
appears.
PUSH
3/08
PowerLite 822p/83c Projector
8. Once the lamp is fully inserted, tighten its screws.
9. Lower the lamp cover into place. (The opening should be
almost covered, and the top of the cover should be flush
with the top of the projector.) Then slide the cover closed
and tighten the screw.
Note:
Be sure to seat the lamp fully and secure the lamp cover. If the
lamp is not properly installed or the cover is loose, the lamp will
not turn on.
10. Reset the lamp timer as described in the next section.

Resetting the Lamp Timer

You must reset the lamp timer after replacing the lamp to clear
the warning message. Follow the steps
Replace the Lamp
below.
Note:
Do not reset the lamp timer if you have not replaced the lamp. If
you do, the Lamp Hours will not accurately reflect the number of
hours that the lamp has been used.
1. Connect the power cable and turn on the projector.
PowerLite 822p/83c Projector 13
-