Asus P5VD2-VM SE User Manual page 70

DRAM Timing [Auto]
When this item is set to [Auto], [Turbo], or [Ultra], the DRAM timing parameters are
set according to the DRAM SPD (Serial Presence Detect), Turbo, or Ultra.
When set to [Manual], you can manually set the DRAM timing parameters. The
Configuration options: [Manual] [Auto] [Turbo] [Ultra]
The following items appear when the DRAM Timing item is set to [Manual].
DRAM CAS# Latency [4]
Controls the latency between the SDRAM read command and the time the data
actually becomes available.
Configuration options: [2] [3] [4] [5]
Precharge to Active(Trp) [4T]
Configuration options: [2T] ~ [5T]
Active to Precharge(Tras) [7T]
Configuration options: [5T] ~ [20T]
Active to CMD (Trcd) [4T]
Configuration options: [2T] ~ [5T]
AGP & P2P Bridge Configuration
AGP & P2P Bridge Configuration
Primary Graphics Adapter
AGP Aperture Size
AGP 3.0 Mode
OnChip VGA Configuration
Primary Graphics Adapter [PCIE]
Allows selection of the graphics controller to use as primary boot device.
Configuration options: [PCI] [Onboard VGA] [PCIE]
AGP Aperture Size [128MB]
Configuration options: [32MB] [64MB] [128MB] [256MB] [512MB] [1GB]
AGP 3.0 Mode [8X]
Configuration options: [8X] [4X]
OnChip VGA Configuration
Onboard VGA Frame Buffer Size [128MB]
Allows you to set the onboard VGA Frame buffer size.
Configuration options: [8MB] [16MB] [32MB] [64MB] [128MB] [256MB]
2-22
[PCIE]
[128MB]
[8X]
Manual DRAM Frequency
Setting or AUTO by
SPD
Chapter 2: BIOS setup