Transferring Data To Another Classpad Unit - Casio ClassPad 330 Hardware User's Manual

2-4 Transferring Data to Another ClassPad Unit

This section details the steps you should perform in order to transfer data from one ClassPad
unit to another.
u ClassPad Operation
(1) Use the procedure under "Connecting to Another ClassPad Unit" on page 2-2-1 to
connect the two units.
(2) Use the procedure under "2-3 Configuring Communication Parameters" to configure the
parameters of the two units as shown below.
Cable Type: 3pin cable
Speed (3Pin): 115200 bps
Wakeup Enable: On
• If the speed settings of the two ClassPad units are different from each other, the
slower setting is used.
The remaining steps of this procedure are marked Sender to indicate steps and
information that apply to the sending device, or Receiver to indicate receiving device
steps and information.
Sender
(3) In the Communication application, tap [Link], and then [Transmit], or tap E .
• This displays the Select Data dialog box.
Sender
(4) Select the data you want to send.
• For more information, see "Selecting Data for Transfer" on page 2-4-3.
Sender
(5) Tap [OK].
2-4-1
Transferring Data to Another ClassPad Unit
20110901