Storage Interface
Chipset:
-
7 x SATA 6Gb/s connectors (SATA3 0~6) supporting up to 7 SATA 6Gb/s
devices
-
1 x eSATA 6Gb/s connector on the back panel supporting up to 1 SATA 6Gb/s
device
* A ctual transfer rate is dependent on the device being connected.
-
Support for RAID 0, RAID 1, RAID 5, RAID 10, and JBOD
USB
Chipset:
-
U p to 4 USB 3.0/2.0 ports (2 ports on the back panel, 2 ports available through
the internal USB header)
-
U p to 10 USB 2.0/1.1 ports (2 ports on the back panel, 8 ports available
through the internal USB headers)
Etron EJ168 chip:
-
Up to 2 USB 3.0/2.0 ports on the back panel
* B e sure to connect your USB device(s) to the USB 2.0/1.1 ports before the USB 3.0
Internal
1 x 24-pin ATX main power connector
1 x 8-pin ATX 12V power connector
Connectors
7 x SATA 6Gb/s connectors
1 x APU fan header
4 x system fan headers
1 x front panel header
1 x front panel audio header
1 x S/PDIF Out header
1 x USB 3.0/2.0 header
4 x USB 2.0/1.1 headers
1 x serial port header
1 x Clear CMOS jumper
1 x Trusted Platform Module (TPM) header
1 x power button
1 x reset button
1 x Clear CMOS button
Back Panel
1 x PS/2 keyboard/mouse port
1 x D-Sub port
Connectors
1 x DVI-D port
1 x optical S/PDIF Out connector
1 x HDMI port
1 x DisplayPort
4 x USB 3.0/2.0 ports
2 x USB 2.0/1.1 ports
1 x eSATA 6Gb/s connector
1 x RJ-45 port
6 x audio jacks (Center/Subwoofer Speaker Out/Rear Speaker Out/Side Speaker
Out/Line In/Line Out/Microphone)
driver is installed. (Refer to the labels in section 1-8, "Back Panel Connectors.")
- 11 -
Hardware Installation