Menu Operations - JVC KD-HDR71BT Instruction Manual

Menu operations

Menu item
LOUD
(Loudness)
VOL ADJUST
(Volume adjust)
SUB. W
(Subwoofer)
SUB.W LPF *7
(Subwoofer low-
pass filter)
SUB.W LEVEL *7
(Subwoofer level)
HPF *7
(High-pass filter)
(KD-AHD75BT
only)
HPF *7
(High-pass filter)
(KD-HDR71BT
only)
BEEP
(Keytouch tone)
AMP GAIN
(Amplifier gain)
SSM
AREA
(Frequency
tuning interval)
MONO
(Monaural mode)
SID
BLEND HOLD
IF BAND
(Intermediate
frequency band)
RADIO TIMER
*7 Displayed only when <SUB.W> is set to <ON>.
24 | ENGLISH
Selectable setting (Initial: [XX])
ON: Boosts low and high frequencies to produce a well-balanced sound at
a low volume level.
[OFF]: Cancels.
-05 — +05 [00]: Presets the volume adjustment level of each source,
compared to the FM volume level. Before adjustment, select the source you
want to adjust. ("VOL ADJ FIX" appears if "FM" is selected.)
OFF: Cancels.
[ON]: Turns on the subwoofer output.
LOW 55Hz/MID 85Hz/[HIGH 120Hz]: Audio signals with frequencies
lower than 55 Hz/85 Hz/120 Hz are sent to the subwoofer.
00 — 08 [08]: Adjusts the subwoofer output level.
LOW 100Hz/MID 120Hz/HIGH 150Hz: Activates the High Pass Filter.
Audio signal with frequencies lower than 100 Hz/120 Hz/150 Hz are cut off
from the front/rear speakers.
[OFF]: Deactivates. (All signals are sent to the front/rear speakers.)
ON: Activates the High Pass Filter. Low frequency signals are cut off from
the front/rear speakers.
[OFF]: Deactivates. (All signals are sent to the front/rear speakers.)
[ON]/OFF: Activates or deactivates the keypress tone.
LOW POWER: Limits the maximum volume level to 30. (Select if the
maximum input power of each speaker is less than 50 W to prevent
damaging the speakers.)
[HIGH POWER]: The maximum volume level is 50.
For settings, page 7. (Displayed only when the source is "FM" or "AM".)
[AREA US]: For North/Central/South America, AM/FM intervals: 10 kHz/200 kHz.
AREA EU: For any other areas, AM/FM intervals: 9 kHz/50 kHz.
AREA SA: For some South American countries, AM/FM intervals: 10 kHz/50 kHz.
Displayed only when the source is "FM".
[OFF]: Enables stereo FM reception.
ON: Improves the FM reception but stereo effect will be lost.
The 12-digit SIRIUS identification number appears on the display. (Displayed
only when SIRIUS Satellite Radio is connected.)
For settings, page 6. (Displayed only when the source is "FM" or "AM".)
[AUTO]: Increases the tuner selectivity to reduce interference noises
between adjacent stations. (Stereo effect may be lost.)
WIDE: Subject to interference noises from adjacent stations, but sound
quality will not be degraded and the stereo effect will remain.
For settings, page 7.