Installing The "Liveviewer - Hitachi CP-A221N User Manual

1. Connection to the network

1.2 Installing the "LiveViewer"

1.2.1 Installing the "LiveViewer"
The "LiveViewer" software needs to be installed on all the computers to connect
to the projector through a network.
You need to log in as an administrator user to install the software.
1) Turn on the computer.
2) Shut down all applications.
3) Insert the accompanying CD-ROM into the computer's CD-ROM drive.
NOTE • After sequence 3), the User Account Control (UAC) dialog will appear
(if you are using Windows Vista
continue installation.
4) After a moment, the Choose Setup Language
dialog will appear as shown on the right. Select
what you like to use in the list, and click the [OK].
NOTE • If the Choose Setup Language dialog doesn't appear, proceed as follows:
(1) Click on the [Start] button on the toolbar and select the "Run".
(2) Enter E:\setup.exe and then press the [OK].
If your CD-ROM drive is not drive E on your computer, you will need to
replace E with the correct drive letter assigned to your CD-ROM drive.
If the software has been already installed, Uninstallation will be done. Click
the [Cancel] button, then uninstallation will be canceled. If you uninstalled the
software by miss-operation, please re-install the software from first procedure.
5) After a moment, the Welcome dialog will appear
as shown on the right. Press the [Next].
6
® or Windows ® 7). Please click the [Allow] to