Messages List - Sony VPL-SX535 Operating Instructions Manual

Messages List

When any of the messages listed below appears on the projected image, address the problem in
accordance with the table below.
Messages
High temp.! Lamp off in
1 min.
Frequency is out of
range!
Please check Input-A
Signal Sel.
Please replace the Lamp
and clean the Filter.
Projector temperature is
high. High Altitude
Mode should be "On" if
Projector is being used
at high altitude.
Not applicable!
The panel keys are
locked!
Projector will shutdown
soon
Press (Pow) Key to
Restart
Lamp Dimming
Meaning/Remedy
Check the items below.
• Check if nothing is blocking the ventilation holes.
• Check if the air filter is not clogged.
• Check if the Installation Attitude in the Installation menu is
set correctly.
Change the output setting of the connected equipment to one
for signals supported by the projector.
Set "Input-A Signal Sel." to "Auto" or select the input signal
type to suit to the input signal.
Replace the lamp with a new one and clean the air filter. The
message appears whenever you turn on the power until you
replace the lamp and reset the lamp timer.
When not using the projector at an altitude of 1,500 m or
higher, check the items below.
• Check if nothing is blocking the ventilation holes.
• Check if the air filter is not clogged.
• Check if Installation Attitude in the Installation menu is set
correctly.
Invalid key was pressed.
"Panel Key Lock" is set to "On."
The ?/1 key was pressed and the projector will be shut down
soon. To cancel shutdown, press the ?/1 key again (the
projector will remain on). To turn off the projector directly,
press and hold the ?/1 key.
Reduces lamp output when "With Static Signal" is set. When
any change in signal is detected, or an operation (remote
control or control panel) is performed, normal brightness is
restored.
Page
3, 3,
24, 36
42
22
34, 36
3, 3,
24, 36
–
21
14
22
31
Messages List