Sony VPL-SX535 Operating Instructions Manual page 23

Notes
*1: This may not be optimum depending on the input signal. In this case set manually according to
the connected equipment.
*2: When "Standby Mode" is set to "Low," the network and network control function cannot be
operated while the projector is in standby mode.
*3: This varies depending on the "Lamp Mode" setting.
*4: As the lamp is dimmed gradually, you may not notice any change in brightness. You might only
notice that the lamp has dimmed when its brightness is restored after there is a change in input
signal.
*5: This mode does not work for about three minutes after the lamp lights. A change in signal may
not be detected depending on the input image. The lamp may become brighter at intervals during
lamp dimming. However, this is not a malfunction. If With No Input is set, it takes priority.
*6: Select "Off" to avoid entering standby mode when there is no input signal.
The Connection/Power Menu
23