Novell Netware 4.1X Or 4.2 Only - HP D5970A - NetServer - LCII Installation Manual

Chapter 5
(press Esc) the manual install and return to the NWConfig
screen.)
11. Select Save parameters and load driver to continue.
12. For each additional adapter you want to install, respond to
the prompt and then repeat steps 7-11.
13. To complete the driver installation process, press the Esc
key until you arrive back at the Installation Options screen.
14. To return to the console prompt, choose Exit.
NOTE If the adapter cannot transmit or receive
following the installation, you may need to
modify the frame type in the
AUTOEXEC.NCF file.

Novell NetWare 4.1x or 4.2 Only

Use the NetWare install program to install the HP NetServer
10/100 adapter driver in Novell NetWare 4.1x. For Novell
NetWare 3.11, 3.12 and 3.2, see the ReadMe files. The
following procedure is a condensed description of the
installation process:
NOTE
Prior to installing, either load DOS or
NetWare drivers from your computer's
CD-ROM drive or create a floppy disk from
the HP NetServer 10/100TX PCI LAN
Adapter Drivers CD using the
MAKEDISK.BAT utility. See the Making a
Setup Floppy Disk section earlier in this
guide.
1. From the NetWare console, type LOAD INSTALL and
press Enter.
2. From the Installation Options screen, choose Driver
options and press Enter.
3. Choose Configure network drivers and press Enter. If
any drivers are already loaded, a list of them appears.
4. Choose Select an additional driver and press Enter. A
12
Configuring the Adapter and Installing Drivers