HP ProBook 5220m - Notebook PC User Manual page 131

Select
Boot Options
Device Configurations
To do this
●
Set a Startup Menu delay (in seconds).
●
Set the MultiBoot Express Boot Popup delay in seconds.
● Enable/disable Custom Logo (disabled by default).
●
Enable/disable Display Diagnostic URL (enabled by
default).
●
Enable/disable CD-ROM boot (enabled by default).
●
Enable/disable SD Card boot (enabled by default).
●
Enable/disable floppy boot (enabled by default).
●
Enable/disable PXE Internal NIC boot (enabled by
default).
●
Enable/disable Unified Extensible Firmware Interface
(UEFI) Boot Mode (disabled by default).
● Set the Express Boot Popup delay in seconds.
●
Set the boot order.
● Enable/disable USB legacy support (enabled by default).
When enabled, USB legacy support allows the following:
◦
Use of a USB keyboard in Computer Setup even
when a Windows® operating system is not running.
◦
Startup from bootable USB devices, including a hard
drive, diskette drive, or external optical drive
connected by a USB port to the computer.
● Enable/disable fan always on while connected to an AC
outlet (enabled by default).
●
Enable/disable Data Execution Prevention. When
enabled, the processor can disable some virus code
execution, which helps to improve computer security.
●
Enable/disable LAN Power Save (select models only).
When enabled, saves power by turning off the LAN when
not in use (enabled by default).
● SATA (Serial Advanced Technology Attachment) device
mode. The following options are available:
◦
AHCI (Advanced Host Controller Interface)
◦
IDE (Integrated Drive Electronics)
Computer Setup menus 119